Enable IPv6 Trap Notifications

About this task

Perform this procedure to enable SNMP traps when maximum number of IPv6 routes are reached.

Note

Note

Different hardware platforms support different parameter ranges. Use the CLI Help to see the available range.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enable max-routes trap:

    ip vrf WORD<1–16> ipv6–max-routes-trap enable

Example

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#ip vrf vrfRED ipv6-max-routes-trap enable

Variable definitions

Use the data in the following table to use the ipv6-max-routes-trap command.

Variable

Value

enable

Enables SNMP trap generation based on the configured number of maximum IPv6 routes. The default is enabled.